Customization: | Available |
---|---|
After-sales Service: | 1 Years |
Warranty: | 1 Years |
Still deciding? Get samples of $ !
Order Sample
|
Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
---|
Payment Methods: |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
---|---|
Support payments in USD |
Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
---|
Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
---|
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Daily Maintenance
1. Purge the spray gun by pointing it into the booth and pressing the purge button.
2. Disconnect the powder feed hose from the pump.
CAUTION: Never blow air through the feed hose from the spray gun to the pump. Doing so could force powder through the pump air tubing into the valves, regulators, and gauges in the control unit, causing them to fail.
3. Point the spray gun into the booth and blow the powder out of the hose and gun with low-pressure compressed air.
4. See Figure 5-2. Disassemble the powder path using the following steps.
a. Remove the flat spray nozzle (6), or any installed optional nozzle.
CAUTION: The electrode assembly (2) projects several inches past the end of the body (1). To avoid damaging the electrode assembly when removing the inlet adapter (3) from the body, pull the inlet adapter straight off the body, parallel with the body centerline.
b. Remove the hose adapter (7) from the inlet adapter.
c. Loosen the set screw (4) in the body. Pull the inlet adapter straight off the gun body.
5. Clean the body, electrode assembly, and all removed parts with a low-pressure air gun. Wipe the parts with a clean, dry cloth.
6. Carefully remove fused powder from the parts with a wooden or plastic dowel or similar tool. Do not use tools that will scratch the plastic. Powder will build up and impact fuse on any scratches.
7. If necessary, remove any O-rings and clean the parts with a cloth dampened with isopropyl or ethyl alcohol. Do not immerse the spray gun in alcohol. Do not use any other solvents.
8. Replace any worn parts and assemble the spray gun.
Output Voltage and Current
|
|
Maximum rated output voltage at the electrode
|
95 kV + 10%
|
Maximum rated output current at the electrode
|
100 uA + 10%
|
Air Pressure
|
|
Purge air
|
5.5−6.5 bar (80−95 psi at 227−255 l/min (8−9 scfm)
|
Gun air
|
0.34 bar (5 psi) 6 l/min (0.2 scfm)
|
Minimum input pressure
|
4.13 bar (60 psi)
|
Maximum input pressure
|
6.89 bar (100 psi)
|
These findings are then integrated into the design of complex coating systems to tailor solutions for customers.
Affiliated companies in Germany, the United Kingdom, the United States, Italy, France, India, Spain and Mexico and an extensive international distributor network in more than 60 countries/regions sell products to a wide range of industrial users.